#ATARI 800 DISK ARCHIVE DRIVER#
#ATARI 800 DISK ARCHIVE UPGRADE#
#ATARI 800 DISK ARCHIVE PLUS#

It is nice to have the Personality slot opening a bit wider than it is originally, so you can pass ribbon cable and auxiliary connectors cables freely. Since you already have all that was required separately, you may proceed with the installation. To get rid of it youвЂќll have to gently pry and push four snap-ins you find accessible on the bottom of the backplane PCB. What you should have now, is the backplane PCB together with the CPU board and the plastic part that forms cartridge slot covers and expansion cards compartment. Now the aluminum plate вЂ“ it holds to the PCB by 4 expansion plugs вЂ“ they are made from two parts вЂ“ one is a pin that was inserted in the collar that expanded and made connection permanent, you need to use a small flat-headed screwdriver to push it all the way out, so youвЂќll be able to remove the collar. After this, disconnect the 4 pin header leading from the backplane to the power board, and try to separate the casting from the backplane вЂ“ it will come off with the power board, but this is the way it should be. YouвЂ™ll find loads of screws to be removed on the bottom side of the cast holding an aluminum plate to the top part. Now, since you have a clear view of the power board and aluminum casting covering most of the backplane, disconnect the internal speaker and remove the whole casting with all that is connected to it from the case. Now youвЂ™re able to open the case вЂ“ lift the top of the enclosure just enough to get a hold on the keyboard ribbon вЂ“ disconnect it from the backplane вЂ“ please take a closer look at how it is connected вЂ“ ribbon has a plug wider than the connector on the backplane (motherboard) and youвЂќll have to connect it back just the way it was when reassembling the unit. After this, youвЂќll have to turn the unit upside-down and unscrew 5 screws in the corners, and in the middle of the front edge.

#ATARI 800 DISK ARCHIVE PLUS#

All you need to do is remove the trap-door, all the expansion cards that you have inside (this includes all three RAM carts plus the Personality/ROM board. Note вЂ“ ALL MENTIONED COLOURS OF WIRE ARE FOR REFERENCE ONLY! DO NOT FOCUS ON COLOURS up to 52k of memory in Colleen mode (configurable).64k/320k/576/1088k total memory available in XL/XE mode.1MB Axlon compatible memory expansion for Colleen mode.build in FAT32 loader (SIDE) with both ATR and XEX file handling.

#ATARI 800 DISK ARCHIVE DRIVER#

build in, configurable PBI CF card storage (works as PBI in XL/XE mode, and through SDX driver in Colleen mode).4 slots for OS separate for Colleen and XL/XE mode.

#ATARI 800 DISK ARCHIVE UPGRADE#

The ultimate upgrade for the original Atari 800 computer!

Atari 800 disk archive